Assembly Instructions Caution: You must read this before you proceed Please look underneath table top for hardware packs TABLE Caution: This Table is NOT a TOY. Keep your child/children at bay during the assembly process. The Table and its parts are heavy, whenever lifting or moving them, two adults are needed to execute these actions.
Parts List Label Picture Description QTY A Table Top 1 B Expansion Board of Table Top 1 C Leg 4 Hardware Description QTY 1 Bolt (M8x65mm) 9 2 Spring Washer (M8/15x2mm) 9 3 Washer (M8/19x2mm) 9 4 Allen Key 1 Label Picture Page 2 OF 10
Assembly Preparation Before Beginning Assembly: Assembly Steps OVERVIEW Expansion Board of Table Top (B) Table Top (A) Leg (C) FRONT FACING This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 4 3 1 2 C A With assistance from your adult partner, carefully place the Table Top(A) facedown on a clean, non-marring surface. Attach Leg(C) to Table Top(A) using Bolts(①), Spring Washers(②) and Washers(③) with Allen Key(④). Repeat the same process with three remaining Legs. Do not fully tighten Bolts.
Step 3 With assistance from your adult partner, carefully stand the Table up. Exert pressure floorwards, onto the Table with both your hands. This pressure will help the Legs and Table Top reach full alignment status. Check for wobbles on a LEVEL surface. If no wobbles are found proceed to tighten Bolts in a sequential manner, until evenly secured. When tightening Bolts tighten sequentially. Do not tighten any Bolt fully and then move on towards the next one.
Extention Steps: To Extend the Table: Step 1 A A Unlock the Metal Fasteners under the Table Top(A). With assistance from your adult partner, gently pull the Table Top(A) outwards to open. Caution: Do not Lean on or apply pressure to the Table when it is pulled open. This could cause damage to the product.
Step 2 2.1 B A 2.2 A B 2.3 A 2.1) Put the Expansion Board of Table Top(B) in the middle of the Table until the iron pins of Expansion Board of Table Top(B) fits in the housing of Table Top(A). 2.2) With assistance from your adult partner, push the Table Top(A) inwards until the iron pins of Expansion Board of Table Top(B) fits in the holes of Table Top(A). Caution: Keep hands away from the Table Top(A) and Expansion Board of Table Top(B) when pushing the Table Top to avoid pinching hazards.
To Retract the Table: Step 1 B 1.1 A B 1.2 A 1.1) Unlock the Metal Fasteners under the Table Top(A). With assistance from your adult partner, gently pull the Table Top(A) outwards to open. 1.2) Remove Expansion Board of Table Top(B). Caution: Do not Lean on or apply pressure to the Table when it is pulled open. This could cause damage to the product.
Step 2 2.1 B A 2.2 A 2.1) With assistance from your adult partners, push the Table Top(A) inwards until they meet. Caution: Keep hands away from the Table Top(A) when pushing it closed to avoid pinching hazards. If you can not push the Table Top(A) inwards, Just slightly shake the Table Top(A). 2.2) Lock the Metal Fasteners under the Table Top to lock it into place as shown in the above picture. Your Table is retracted and is now ready for use. This Table can only be used on a flat, level surface.
Care & Maintenance Do not put hot items directly on furniture surface Do not clean furniture with harsh cleansers or polish. To obtain the longest lifespan of your outdouocrtps,romdinimizing exposure to direct sunlight is recommended. Children should not climb or jump on the furniture. Do not write on furniture without a padded barrier to protect the surface. To obtain the longest lifespan of your outdoor products, avoid extended and lengthy exposure to rain, snow, and direct sunshine.
