Assembly And Installation Instructions

Page 4/4

Mounting Screw (B)

Green Grounding

Screw (C)

Lock Nut (F)

Wire Nut (E)

Ball Nut (G)

Rubber Pad (H)

Cross Bar (A)

Headless Screw (D)

The following parts are available for re-order if damaged or missing.

Spare Parts List:

A: 8-1/4"

B: 9"

C: 11"

A: 10"

B: 10"

C: 12"

---In 3H or 6H Mode, the light is still on full brightness, even though it has been 3 hours or 6 hours

after dusk, respectively:

1. Make sure no motion could be picked up by the sensor.

2. Make sure that mode entry is not in manual override.

---After performing 3H or 6H Mode, the light stays on full brightness after 3 minutes:

1. Make sure there is no movement that could be picked up by the sensor.

2. Adjust the time knob counterclockwise to reduce the delay shut-off time.

----In 3H or 6H Mode, the light turns off completely, instead of low level brightness, after 3 minutes:

1. Make sure the bulb you installed is a medium base bulb or LED dimmable bulb.

2. Make sure the bulb is not burned out.

3. make sure the low level is not at the 0% position.

-- The light blinks:

1. Make sure the light is not mounted near a barbecue, air conditioner or other heat source.

2. Adjust the sensitivity knob counterclockwise to avoid unnecessary triggering like a passing car or

reflecting objects.

3. Make sure the bulb is medium base bulb or Led dimmable bulb.

LIMITED WARRANTY:

Mounting Hardware

5418MM (1 SET)

Mounting Hardware

5419MM (1 SET)

Mounting Hardware

5144MM (1 SET)

Glass Shade(1pc)

9475CS

9857CS