Assembly Instructions

ManualsBrandsBeachcrest Home ManualsBathroom Cabinets & ShelvingX Frame 18" W x 36.25" H x 14" D Free-Standing Bathroom Shelves

ASSEMBLY INSTRUCTIONS

ADULT ASSEMBLY REQUIRED

This product requires assembly by an adult because of the small parts. Care should be

taken in unpacking and assembling this item to keep the small parts away from children.

WARNING

Young children can be seriously injured or killed, if furniture tips over.

Don’t use this item for a TV stand.

Use angle-braces or anchors to secure furniture to the wall.

X-Frame 3-Shelf Storage Tower

WHITE

ESPRESSO

Summary of content (7 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS X-Frame 3-Shelf Storage Tower WHITE ESPRESSO ADULT ASSEMBLY REQUIRED This product requires assembly by an adult because of the small parts. Care should be taken in unpacking and assembling this item to keep the small parts away from children. WARNING Young children can be seriously injured or killed, if furniture tips over. Don’t use this item for a TV stand. Use angle-braces or anchors to secure furniture to the wall.
PAGE 2
THIS SHELF UNIT WILL HOLD UP TO 25 POUNDS PER SHELF OR A TOTAL OF 75 POUNDS. DO NOT LOAD EACH SHELF WITH MORE THAN 25 POUNDS. IF LOADED WITH MORE THAN 25 POUNDS PER SHELF AS THIS MAY CAUSE DAMAGE TO THE SHELF AND MAY CAUSE SERIOUS INJURY OR DEATH.
PAGE 3
PARTS LIST NO PARTS QTY DESCRIPTION A 12PCS LONG SCREW 5x45mm B 4PCS SCREW 4x35mm C 12PCS PLASTIC CAP D 2PCS SCREW 4x40mm E 2PCS PLASTIC ANCHOR F 1PC ALLEN WRENCH 1 1PC TOP BOARD 2 2PCS SIDE FRAME 3 2PCS SHELF 4 1PC BACK CROSS BAR 5 1PC FRONT CROSS BAR TOOLS NEEDED FOR ASSEMBLY: PHILIPS SCREWDRIVER (NOT INCLUDED) THE USE OF POWER SCREWDRIVER IS NOT RECOMMENDED
PAGE 4
STEP 1 1. Put the top board (1) upside down on a soft padded surface. 2. Attach the back cross bar (4) to the top board (1) by inserting 2 wood screws (B) through the holes on the back cross bar (4) then tighten to the top board (1) by using a Philips screwdriver. 3. Repeat the above step to assemble the front cross bar (5). STEP 2 1.
PAGE 5
STEP 3 1. Attach the top board (1) to Pre-assembled side panels (2) by inserting 4 long wood screws (A) through the holes on the side frame (2) then tighten to the back cross bar (4) and the front cross bar (5) by using the Allen wrench (F). STEP4 1. Press 12 Plastic caps (C) into the wood screw holes on side frame (2). 2. If added pressure is needed to keep the plastic cap in place – cover the cap with a piece of paper and tap lightly with a hammer to secure the cap.
PAGE 6
STEP5 1. Drill 2 holes on the wall by using the template drawing(included) w/hole positions as a guideline. 2. Insert 2 plastic anchors (E) into the 2 holes on the wall. 3. Insert 2 wood screws (D) through the holes on the back cross bar (4) and tighten to the 2 plastic anchors (E) with a Philips screwdriver.
PAGE 7
ENJOY YOUR NEW 3-Shelf Storage Tower NOW ! Attention Adults: The cabinet should be checked periodically for damage or loose screws/parts. Take appropriate action necessary to correct the hazard such as tightening of screws and taking any damaged parts away from the children. Thank you for purchasing this item.