Assembly Instructions ASSEMBLY RATING Tools Required for Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
Thank you for your purchase! We hope you will enjoy your new product for many years to come. Our commitment to providing quality products does not simply end when a purchase is made. We stand behind our products and will provide any support needed in order for you to fully enjoy your purchase. Your satisfaction is the greatest recognition we could have. Because we value your trust in our company, we will do our best to meet your service expectations.
Page 3 of 12
PRE-ASSEMBLY INTRODUCTION Unless you are particularly adept at assembling flat-pack/knock-down furniture, we understand building ready-to-assemble furniture can be a frustrating experience for some. To help avoid confusion and to make the assembly process quicker and smoother, we have provided some helpful tips. Before you begin the assembly, please read the following: 1. 2. 3. 4. 5. 6. 7.
CAM LOCK FASTENER ASSEMBLY INSTRUCTIONS ly Page 5 of 12
Parts List #1 x 5 pcs Drawer A Base #2 x 1 pc Drawer A Rear #3 x 1 pc Drawer A Right Side #4 x 1 pc Drawer A Left Side #5 x 1 pc Drawer A Front #6 x 1 pc Back Cover #7 x 4 pcs Drawer B Rear #8 x 4 pcs #9 x 4 pcs Drawer B Left Side #10 x 4 pcs Drawer B Front #11 x 1 pc Panel A #12 x 3 pcs Panel B #13 x 1 pc Panel C #14 x 1 pc Panel D #15 x 1 pc Panel E #16 x 1 pc Panel F #17 x 1 pc Panel G #18 x 1 pc Right Side Panel #19 x 1 pc Left Side Panel #20 x 1 pc Top Panel Drawer B Right Side Not
Before you begin, please read “Assembly and Care Advice”, “Pre-Assembly Introduction” and “Cam Lock Fastener Assembly Instructions”.
#C x 4 pcs Turn right (clockwise) to tighten Turn right (clockwise) to tighten #A x 4 pcs #B x 4 pcs #G x 1 set #H x 1 pc Page 8 of 12
#C x 16 pcs Turn right (clockwise) to tighten #A x 16 pcs #B x 16 pcs #G x 4 sets #H x 4 pcs Page 9 of 12
#E x 1 pc #F x 1 pc Turn right (clockwise) to tighten #D x 20 pcs #E x 10 pcs #F x 10 pcs Turn right (clockwise) to tighten Page 10 of 12
#D x 7 pcs #E x 4 pcs #F x 4 pcs Turn right (clockwise) to tighten #I x 20 pcs Page 11 of 12
SAFETY STRAP TO PREVENT TIP-OVER Drywall: Select a location where you want the unit to be mounted. Place the assembled unit against the wall and, on the wall, mark the location where the anchor (#L) will be placed. Drill a hole slightly smaller then the size of the screw (#N). Push the anchor (#L) as far as it will go with your finger. Tap gently with a hammer until the anchor (#L) is flush with the wall surface.
