User`s guide

75.5753.02 LZR-MICROSCAN 20140107 Page 7 of 12
Power
Power
Supply
Pwr Sup
Harness
1a
Power
Supply
110 V
Soruce
2
3
If using installer provided power
supply, wire nut output of power
supply to Power Supply Harness.
Wire nut input of power supply to
110V power source.
Plug Power Supply or Power
Supply Harness into hub port
labeled Power.
INSTALLATION (cont.)
SYSTEM HARNESS
WIRE
COLOR:
Grey Grey Orange Orange Purple Purple Blue Blue
SIGNAL:
Knowing Act Activation
Home Switch Monitoring Door 1 Monitoring Door 2
NOTES: Push Plates Provided Only used with monitored door controls
Monitoring* (if applicable)
* SEE APPLICATION NOTES OR CONTACT BEA FOR TECHNICAL SUPPORT
Door Type: Single
Pair / Dual Egress
(single/master control)
Pair / Dual Egress
(independent controls)
System
Harness:
1 blue
+
1 purple
1 blue
+
1 purple
1 blue
+
1 purple
1 blue
+
1 purple
2 blues 2 purples
Door Control
Monitoring:
1st leg 2nd leg 1st leg 2nd leg
1st
Control
2nd
Control
Wire nut System Harness wires to monitoring wires of door control:
NOTES:
1: When using BEA provided
power supply, if a NEMA 5-15R
outlet is not available in door
header, cut off NEMA 5-15P
plug and wire nut to 110V AC
observing polarity and grounding.
By cutting off plug, system
changes from UL Listed to UL
recognized.
Any 15W Class II power supply
may be used.
Wiring (cont.)
Power
Supply
1b
If using BEA provided power
supply, cut plug off of harness and
strip wires
1
.