User`s guide

75.5753.02 LZR-MICROSCAN 20140107 Page 3 of 12
PREPARATION
IMPORTANT:
In order to guarantee proper installation, instructions must be followed in order!
Verify operation/functionality of door control and operator prior to system installation.
Sensors
1 2
Determine on which side of door
Door Loop will be installed and cut
to shortest length to avoid loop in
detection zone.
Take sensor to be mounted on
loop side and remove Blank
Endcap closest to door hinge
1
.
Hub
1 2
Install hub in door header,
centered and in an easily
accessible location.
Plug System Harness into hub port
labeled System. Do not plug in
any other harnesses.
3
Route Master Sensor Harness
through Door Loop.
5
Affix Door Loop to sensor with
Pass-Through Endcap and three
(3) screws
2
.
4
Plug Master Sensor Harness into
sensor at closest port.
NOTES:
1: For left sensor, remove left
Blank Endcap or for right sensor,
remove right Blank endcap.
2: Pull extra Master Sensor
Harness slack through Door
Loop (away from sensor) before
tightening endcap screws.