User`s guide

Page 2 of 12 75.5753.02 LZR-MICROSCAN 20140107

Shut off all power going to header before attempting any wiring procedures.

Maintain a clean & safe environment when working in public areas.

Constantly be aware of pedestrian trafc around the door area.

Always stop pedestrian trafc through the doorway when performing tests that may result in unexpected reactions by the door.

ESD (electrostatic discharge): Circuit boards are vulnerable to damage by electrostatic discharge. Before handling any board
ensure you dissipate your body’s ESD charge.

Always check placement of all wiring before powering up to ensure that moving door parts will not catch any wires and cause
damage to equipment.

Ensure compliance with all applicable safety standards (i.e. ANSI A156.10) upon completion of installation.

DO NOT attempt any internal repair of the components. All repairs and/or component replacements must be performed by
BEA, Inc. Unauthorized disassembly or repair:
1. May jeopardize personal safety and may expose one to the risk of electrical shock.
2. May adversely affect the safe and reliable performance of the product resulting in a voided warranty.
PRECAUTIONS
Avoid extreme vibrations. Do not cover the sensor.
Avoid moving objects and
light sources in detection
zone.
Avoid highly reflective
objects in the detection
zone.
It is reccommended to
clean the opitcal parts
at least once per year or
more if required due to
environmental conditions.
Do not use
abrasive cleaning
components.
The door conrol unit and
the door header must be
correctly grounded.
Only trained and qualified
personnel may install and
setup the sensor.
Always test the proper
operation of the
installation before leaving
the premises.
The warranty is void if
unauthorized repairs are
made or attempted by
unauthorized personnel.
INSTALLATION
MAINTENANCE
SAFETY
IR laser (Class 1); wavelength 905 nm; max. output pulse power 35 W
CAUTION: Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure
LASER
!
• The device should not be used for purposes other than its intended use. All other uses cannot be guaranteed by the
manufacturer of the sensor.
• The installer of the door system is responsible for carrying out a risk assessment and installing the sensor and the door system
in compliance with applicable national and international regulations and standards on door safety.
• The manufacturer of the sensor cannot be held responsbile for incorrect installations or inappropriate adjustments of the
sensor.