User`s guide

5 Installation (continued)
75.5652.03 20130617 Page 7 of 16
12
Install Photo Beams SBK-30 (Optional)
Beams TX Cable Beams RX Cable
Route to Route to
‘BEAMS’ ‘BEAMS’
1. For complete installation instructions refer to Beams SBK-30 Users Guide (75.5179).
2. Install Beam Transmitter.
3. Install Beam Receiver.
4. Route wiring harness (20.5099) from the Transmitter to DP-Hub and plug into DP-Hub at either one of the locations marked ‘BEAMS’.
5. Route wiring harness (20.5100) from the Receiver to DP-Hub and plug into DP-Hub at the other location marked ‘BEAMS’.
NOTE: See Programming Parameter FB on page 10 section 6-1.
NOTE: If using beams, the DP-Hub will automatically be set to Advanced BodyGuard Safety.
13
Install Power Harness
1. Install transformer in an easily accessible location to the DP-Hub.
2. Route wiring harness (20.5095) from the Transformer to DP-Hub and plug into DP-Hub at location marked ‘POWER’.
NOTE: Alwasy use the BEA supplied transformer and never power the DP-Hub from the door control.
115 VAC
RED
RED BLACK
BLACK
24 V
TRANSFORMER
POWER CABLE
Route to
POWER
RED
BLACK
24 VAC
Beams
Power