User`s guide

5 Installation (continued)
Page 6 of 16 75.5652.03 20130617
11
Install Auxiliary/Push Plate(s) (optional)
Push Plate Wire
Route to ‘AUX’
COM
NO
NC
1. Mount Push Plate(s) or other Knowing Act device(s) to wall, jamb or desired location accessible to trafc ow.
2. Route two wires from Push Plate to DP-Hub and fasten one leg of Push Plate at the rst location of screw terminal marked ‘AUX’ on DP-Hub
and the second leg of Push Plate to second location marked ‘AUX’ on DP-Hub.
NOTE: Make sure the device is wired to the normally-opened (NO) and common (COM) contacts of the device.
NOTE: See Programming Parameter FA on page 10 section 6-1.
Auxiliary/Push Plate
10
Install Eagle(s) (optional)
1. For complete installation instructions refer to Eagle User’s Guide (75.0058).
2. Wire Eagle as displayed above.
3. Mount Eagle Sensor to door header and route Eagle harness (20.5096) through door header and plug into DP-Hub at location marked ‘EG1’.
For two way trafc, repeat the steps above on the opposite side of the door and plug into DP-Hub at location marked ‘EG2’ and make sure that
the Eagle is installed beyond the swing of the door so that the normal operation of the door does not trigger the Eagle.
RED
BLACK
WHITE
GREEN
1 POWER
2 POWER
3 COM
4 N.O.
5 N.C.
Eagle 1 Cable
Route to
‘EG 1’
Eagle 2 Cable
Route to
‘EG 2’
Eagle 1
Eagle 2