Product Manual

16
17
How to Use Spray Tips
The quick–connect on the nozzle extension allows you to switch between
four different quick connect spray tips. Spray tips can be changed while
pressure washer is running once spray gun trigger safety lock is
engaged. The spray tips vary, following the patterns shown above.
spray tips
Follow these instructions to change spray tips:
1. Pull back collar on quick–connect and pull current spray tip off. Store
spray tips in holder provided on the washer or gun (varies by model).
Storing nozzles in the designated holder will help prevent debris from
clogging the tip.
2. Select desired spray tip:
• For a gentle rinse, select white 40° spray tip.
• To scour surface, select yellow 15° or red 0° spray tip.
• To apply detergent, select black spray tip.
3. Pull back on collar, insert new spray tip and release collar. Tug on
spray tip to ensure it is securely in place.
Usage Tips
• For the most effective cleaning, keep spray tip at least 8 to 24 inches
away from cleaning surface.
• If the spray tip comes to close to the surface being cleaned, it may
become damaged. This is especially true if using the red spray tip.
WARNING
The high pressure stream of water that this equipment
produces can cut through skin and its underlying
tissues, leading to serious injury and possible
amputation.
• NEVER exchange spray tips without the trigger safety lock engaged
on the spray gun.
• DO NOT twist spray tips while spraying.
0
o
RED
40
o
WHITE
soaper
BLACK
15
o
YELLOW
To apply detergent, follow these steps:
1. Review use of spray tips.
2. Prepare detergent solution as required by job. Instructions can often
be found on the detergent bottle.
3. Place small filter end of detergent siphoning tube into detergent
container.
NOTE: Make sure the filter is fully submerged in detergent while applying
detergent.
THIS WASHER WILL ONLY DRAW SOAP WITH THE BLACK
SOAPER NOZZLE. WHITE, RED, AND YELLOW NOZZLE WILL
NOT DRAW SOAP.
using black soap nozzle
4. Make sure black spray tip is installed.
5. Ensure garden hose is connected to water inlet. Check that the high
pressure hose is connected to spray gun and pump. Turn water on.
NOTICE
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and without the
water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this instruction
will void warranty.
6. Start engine following the instructions in Starting Your Washer.
7. Apply detergent to surface, using long, even, overlapping strokes.
8. Allow detergent to “soak in” for 5 minutes before washing and
rinsing. Reapply as needed to prevent surface from drying. DO NOT
allow detergent to dry on as this can damage the surface.
IMPORTANT: You must flush the detergent siphoning system after each
use by placing the filter into a bucket of clean water and running the
pressure washer at low pressure for 1-2 minutes.
CAUTION
Chemicals can cause bodily injury and/or property damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergent/soaps. Follow all
manufacturers instructions