Product Manual

30
31
11. To start the machine, plug it in and locate the ON/OFF switch on the side of
the motor and switch it to the ON position (see component chart on page 22
to locate the switch).
7. From here, attach the other end of the high pressure hose to the outlet (A)
on the pump. Pull down on the collar of the quick connect coupler, slide onto
the pump and let go of collar. Pull on hose to ensure the connection is tight.
8. Turn the water supply on, point gun in a safe direction and squeeze the
trigger to purge the pump of air and debris. Do this for at least 30 seconds to
ensure everything has been cleared out.
9. Take a look at all connections to make sure there are no leaks or loose
connections. If the high pressure hose is leaking, it must be replaced.
IMPORTANT: DO NOT siphon standing water for the water supply. Use
cold water (less than 100°F/38°C). Use of hot water can damage seals and
compromise the integrity of the pump over time.
A
A
B
B
axial pump triplex pump
STARTING YOUR ELECTRIC WASHER
IMPORTANT: Before starting the pressure washer, ensure that you
are wearing adequate safety goggles.
WARNING
Risk of eye injury.
Spray can splash back or propel debris such as dirt/rocks.
• Always wear safety goggles when using this equipment or in vicinity
of where equipment is in use.
• Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
• NEVER substitute safety glasses for safety goggles.
• ALWAYS point spray gun in a safe direction and squeeze spray gun
trigger to release high pressure every time you stop engine.
• NEVER aim spray gun at people, animals, or plants.
• DO NOT leave spray gun unattended while machine is running.
• NEVER use a spray gun which does not have a trigger lock or trigger
guard in place and in working order.
• ALWAYS be certain spray gun, nozzles and accessories are correctly
attached. Failure to do so can cause bodily harm or damage to the unit.
STARTING YOUR ELECTRIC WASHER