BE Pressure supply 2500 Watt Inverters Generators : Instruction Manual : Page 19

o p e r a t i o n

• When an electric motor is started, both the overload indicator light (red)

and the output indicator light (green) may go on simultaneously. This

is normal if the overload indicator light (red) goes off after about four

seconds.

• If the overload indicator light (red) stays on, consult your dealer.

1. Connect the ground terminal



• Before connecting an appliance to the generator,

check that it is in good order, and that its electrical

rating does not exceed that of the generator. Then

connect the power cord of the appliance, and start the

engine.

• Be sure all equipment is turned off before plugging in

the power cord.



• The output indicator light (green) will remain lighted during normal

operating conditions.

• If the generator is overloaded or of here is a short in the connected

appliance, the output indicator light (green) will go OFF, the overload

indicator light (red) will go ON and current to the connected appliance

will be shut off.

• Stop the engine if the overload indicator light (red) switches ON and

investigate the overload source.

Grounding

Terminal

**I2500 Image

Output Indicator Light

Overload Indicator Light

Oil Alarm Indicator

I2500_3500 Inverter Generator Manual_2011.indd 19 18/10/2011 2:03:50 PM