Instruction Manual

200798_1 7
Measure the thickness of your back panel that the fire is to be fixed to, for panels 18mm – 22mm attach
the two L shaped angle brackets with the return facing forward. For panels 38mm - 42mm the L shaped
angle bracket returns will need to face backward.
18mm – 22mm Back Panel
38mm – 42mm Back Panel
Angle Brackets
When fitting to a back panel the unit is secured in place by sandwiching the back panel between the
engine unit and the main body (as shown above).
The engine unit needs to be positioned through the back panel. Ensure an electrical supply connection is
made at this stage. Slide the engine through the back panel opening on a diagonal then pull towards you
so that it is straight and the angle clamp brackets are snug behind the back panel. Offer the Stove body
trim up to the engine unit in the opening, using the 4 off ¾ No.6 screws provided. Loosely fix the trim to
the holes provided on the fixing wings. Once all four screws are loosely attached, fully screw the fire into
position. Take care not to overtighten and strip the threads of the hole.
For installations directly into an existing fireplace opening, you will need to secure the main body to
the opening using the two wall fixings points.
Re-attach the main body to the engine unit using the four
fixings and slide the assembled unit into the fireplace opening.
Mark the two wall fixing points and remove the fire from the
opening to enable drilling/wall fixing. Re-position the fire and
make any necessary electrical connections.
Ensure the site is clear of debris before finally securing the
fire to the wall.
The door should be supplied assembled with the upper hinge
pin in position and the lower hinge pin ready to fit to the
assembly. Locate the upper hinge pin in position in the upper
hinge on the main body. Manoeuvre the door so that the
lower pin (supplied) can drop through into the lower hinge
pin. Lock the lower pin in position by fixing the slider
component in position using the M5 Allen bolt. The slider
should rest on top of the pin so as to prevent the pin rising up
out of the lower hinge.
Fitting to a fire surround back panel
Fitting to an existing 16” x 22” opening
Please note wall plugs are not provided
as this will depend on the material the
fire is to be secured to.