Manual

Seite 35 von 38
Troubleshooting
Error Codes
Error Code
Error description
FL
Water tank is full
E2
Malfunction of the inlet temperature sensor
P1
The entire machine is in defrost mode, this is not a
malfunction
Problem
Cause
Solution
Dehumidifier does
not start.
The dehumidifier is
unplugged.
Make sure that the
dehumidifier's mains cable is
fully plugged into the socket.
Watertank is Full.
Empty the Watertank.
The ambient
temperature
is lower than 5 °C or
higher than 32 °C.
Note the
temperature range for which
the unit is designed for.
The dehumidifier
does not dry the
air as desired.
not as desired.
Dirty Filter.
Clean the filter as described.
Room temperature or
air humidity too low.
In the dry season, the
dehumidification capacity is
reduced.
The dehumidifier
is noisy or makes
unusual noise.
Noises.
The dehumidifier is
not placed
horizontally.
Place the appliance on
A flat surface.
The air filter is
clogged.
Clean the filter as described.
The unit "hisses"
slightly.
No fault. The flowing sound of
the refrigerant.
Water leakage
Hose connection is
loose.
Check the hose connection.