Manual

Seite 34 von 37
Cleaning the Filter
•
The filter is located behind the rear intake grille. Remove the intake grille
from the dehumidifier and remove the filter.
•
Use a hoover with a soft brush attachment to remove large debris and dust
deposits.
•
Wash the filter in lukewarm soapy water.
•
Rinse the filter with clean water and let it dry thoroughly.
•
Replace the filter.
Notice:
Do not clean the filter in the dishwasher. Do not operate the
dehumidifier without the filter supplied.
Troubleshooting
Error Codes
Error Code
Error description
FL
Water tank is full
E2
Malfunction of the inlet temperature sensor
P1
The entire machine is in defrost mode, this is not a malfunction
Problem
Cause
Solution
Dehumidifier does
not start.
The dehumidifier is
unplugged.
Make sure that the
dehumidifier's mains cable is
fully plugged into the socket.
Watertank is Full.
Empty the Watertank.
The ambient
temperature
is lower than 5 °C or
higher than 32 °C.
Note the
temperature range for which the
unit is
designed for.
The dehumidifier
does not dry the air
Dirty Filter.
Clean the filter as described.