Manual

Seite 31 von 37
Drainage
When using the water tank
When the water tank is full, the appliance switches off automatically and beeps
to indicate that the water tank is full. The tank full indicator lights up.
The dehumidifier only continues to run after the water tank has been emptied.
Grip each side of the bucket and pull
to remove the bucket from the
dehumidifier, and remove pour the
water.
Gentyly Re-insert the bucket, restart
it.
Note
: Check in the water tank that the float is in the correct position. Do not
remove the float and make sure that it can rotate freely. If the float is removed,
the appliance will not recognise when the water tank is full.
When used with a drain hose
•
By attaching the supplied drain hose, the water can be automatically
emptied into a floor drain. Alternatively, other hoses can be used. ( inner
diameter 0.35 inch)
•
At the back you will find the water outlet. Remove the plug.
•
Attach one end of the drain hose to the drain hole.
•
Direct the other end of the scarf to a drain.
•
ATTENTION!
The drain must be in a lower position than the water outlet of
the appliance. Do not place the appliance on the floor and guide the hose
upwards
!