Specifications

. . . . .
INSTALLATION INSTRUCTIONS
RS-232 Control
DVI Converters: Installation & Operation Guide Edition 1.02 Introduction 9
Installation of the RGB-DVI Converter is complete.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
RS-232 CONTROL
Set up of the RGB-DVI and SD-DVI converters should be done using RS-232 control. The
following procedure details how to establish RS-232 serial control with the DVI converter.
To establish RS-232 control of the DVI converter
1 Connect the supplied RJ11 to DB9 cable to the DVI converter.
2 Connect the control computer to the RS-232 DB9 connector on the supplied cable. DVI
Converters.
3 Open up a serial port terminal on the control computer.
On Microsoft Windows, you can use HyperTerminal for serial communications.
4 Configure the port settings as follows:
• Baud: 9600
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
The RS-232 connection to the DVI Converters is established and the converter can be con-
trolled using the RS-232 command set found in Appendix A, “RS-232 Protocol.”
NOTE:
To avoid recreating the connection parameters each time you reestablish
RS-232 connection to the CXPS, you can save the connection for
subsequent control sessions.