Specifications

INSTALLATION INSTRUCTIONS
RGB-DVI Converter Installation
8 Introduction Edition 1.02 DVI Converters: Installation & Operation Guide
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
RGB-DVI CONVERTER INSTALLATION
Figure 8 illustrates the installation of the RGB-DVI converter. The following procedure
describes the installation process.
To Install the RGB-DVI Converter
Before installing the SD-DVI converter, connect the supplied power adapter to the unit and
plug it into an AC power source. Black Diamond Video recommends the use of a surge
protector.
1 Connect 3 wire, 4 wire, or 5 wire RGB or YUV source to the DB15 HD connector labelled
“RGB/YUV”.
2 Connect the DVI output of the converter to a Black Diamond Video-tested DVI cable.
3 Connect the other end of the DVI cable directly to the Black Diamond Video digital
video processing equipment in your installation, such as the Phantom 800 or CXPS.
4 The Link LED indicator on the converter flashes green when an active connection to
the converter is established.
NOTE:
DVI Converters should be connected as close to the video source as
possible to minimize cable problems such as noise and attenuation.
FIGURE 8.
RGB-DVI Converter installation