Specifications

. . . . .
INSTALLATION INSTRUCTIONS
SDI-DVI Converter Installation
DVI Converters: Installation & Operation Guide Edition 1.02 Introduction 7
To Install the SDI-DVI Converter
Before installing the SDI-DVI converter, connect the supplied power adapter to the unit and
plug it into an AC power source. Black Diamond Video recommends the use of a surge
protector.
1 Connect the 75 Ohm Serial Digital Interface source to the BNC connector labeled SDI
Input.
2 If desired, connect a 75 Ohm Serial Digital Interface output to the BNC connector
labeled SDI Output for loop-through connection to the SDI source.
3 Connect the DVI output of the converter to a Black Diamond Video-tested DVI cable.
4 Connect the other end of the DVI cable directly to the Black Diamond Video digital
video processing equipment in your installation, such as the Phantom 800 or CXPS.
5 The Link LED indicator on the converter flashes green when an active connection to
the converter is established.
Installation of the SDI-DVI Converter is complete.
FIGURE 7. SDI-DVI Converter installation