User's Manual

Radio controls provide a reliable communications link
and fill an important need in portable wireless signaling;
however, there are some limitations which must be
observed.
• For U.S. installations only: The radios are
required to comply with FCC Rules and Regulations as
Part 15 devices. As such, they have limited transmitter
power and therefore limited range.
• A receiver cannot respond to more than one
transmitted signal at a time and may be blocked by
radio signals that occur on or near their operating
frequencies, regardless of code settings.
• Changes or modifications to the device may
void FCC compliance.
• Infrequently used radio links should be tested
regularly to protect against undetected interference or
fault.
• A general knowledge of radio and its vagaries
should be gained prior to acting as a wholesale
distributor or dealer, and these facts should be
communicated to the end users.
FCC Part 15: Class B Digital Device Statement
If the module’s label is not visible when installed, then
an additional permanent label referring to the enclosed
module: “Contains Transmitter Module FCC ID:
QIPELS61-USA” must be placed on the rear panel in a
visible location.
FCC ID: OC7GATEWAYALTE
This devise has been tested and found to comply with
the limits for a Class B digital device pursuant to Part
15 of FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful
interference, and
2. This device must accept interference
received, including interference that may cause
undesired operation.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If the equipment does cause