Instruction Manual

BDIUSA.COM | 19NEED ASSISTANCE? [e-mail]
HEIGHT ADJUSTMENT
The desk base can be adjusted by pressing and holding either the UP or DOWN button until the
desired height is reached.
To program up to four presets, use the up/down buttons to find a desired height, then press “BDI”
followed by a number 1-4. To Change the Movement Program (explained below) follow the Reset
Procedure to Step 4. The display should be flashing “RST”. Press and hold the “1” button (about 5
seconds) until the display flashes “10.1” or “10.2”. You can press and hold the “1” button again to
switch to the other setting. Once the chosen setting is selected finish the Reset Procedure steps 5
and 6.
ONE TOUCH (DEFAULT)—10.1
Once a preset button is pushed, the desk will move to the programmed height. To stop movement,
press any number on the keypad.
CONSTANT TOUCH—10.2
A preset button must remain pressed for the desk to move to the programmed height. To stop
movement, release the button.
TROUBLE SHOOTING
If your desk is not functioning properly it may need to be reset. Follow the RESET procedure on
page 18. If your LED readout displays an error message Er1 confirm that all wired connections are
secure. Then perform the reset procedure above.
KEYPAD LOCK
To lock the keypad:
Press and hold the “BDI” button for about 8 seconds until the LED display reads “LOC”. The keypad
is now locked and cannot be used to move the desk.
To unlock the keypad:
Press and hold the “BDI” button for about 8 seconds until the LED display switches from “LOC” to
the height display. The keypad is now unlocked and can be used as normal.
HEIGHT DISPLAY: INCHES OR CENTIMETERS
To change unit of height measurements (inches or centimeters) follow the Reset Procedure to Step 4.
The display should be flashing “RST”. Press and hold the “2” button (about 5 seconds) until the
display flashes “10.3” or “10.4”. You can press and hold the “2” button again to switch to the other
setting. Once the chosen setting is selected, finish the Reset Procedure steps 5 and 6.
Centimeters—10.3
Inches (Default)—10.4