Instruction Manual

BDIUSA.COM | 11NEED ASSISTANCE? customerservice@bdiusa.com

Channel holds

edge of back panel

ASSEMBLY

STEP 8. ROTATE WIRE TRAY

STEP 9. INSTALL BACK PANEL—OPTIONAL

Rotate the (C6) Wire Tray down as shown. Position the desk. The wire tray may be used to hold

power strips, surge protectors, and power bricks (not provided).

Note: If positioning your desk in the middle of a room, power cords may be routed through the holes on the

(C4) Lower Horizontal Frame.

If positioning your desk away from a wall, the (C7) Back Panel may be installed. The lower edge

goes into the channel on the (C4) Lower Horizontal Frame and is held in place with magnets.

Note: (C7) Back Panel is included with 6101 Large Desk, but is not included with 6103 Compact Desk. It

must be ordered separately (6108).