Operator`s manual

Motor, 48 volt DC - 4 horsepower, 1-10
Motor, electric drive, 1-3, 1-42
Mounting bracket, contactor, 3-5, 3-6
P
Pin, 1-21
Pin lock, 1-18, 1-21, 1-22
Pin, tie rod, 1-2
Placard, 125 volts 15 amps, 1-30
Placard, ANSI standard, 1-30
Placard, battery disconnect, 1-2
Placard, caution serial number, 1-30
Placard, danger do not alter switch, 1-30
Placard, danger electrical hazard, 1-30
Placard, danger foam filled tires, 1-30
Placard, lower control box, 3-11
Placard, lug nut torque, 1-30
Placard, platform capacity, 1-30
Placard, platform identification, 1-30
Placard, pre-start instructions, 1-30
Placard, turn key off, 1-30
Placard, upper control box top, 3-12
Plate, slide mount, 1-21
Platform foot switch, 3-17
Platform mounting bracket, lower, 1-21
Platform mounting bracket, upper, 1-21
Platform rotator, 1-23
Power track link, 1-24
Power trak, 1-24
Pressure reducing cartridge valve, 2-6
Pressure relief cartridge valve, 2-6
Pressure switch, 2-4
R
Rear boom rest, 1-8
Relay circuit board, 3-12
Relay, 12 volt DC, 1-2, 1-13, 3-5, 3-6, 3-8, 4-5
Relay, 24 volt DC, 1-2
Retaining ring, 1-21
Ribbon cable, 18 conductor 18 gauge, 3-12
Ribbon cable, 22 conductor 18 gauge, 3-11, 3-12
Riser bracket, 1-18
Riser lift cylinder, 1-18
Riser support, 1-8
Riser support pad, 1-8, 1-18
Rotation bearing, 1-2
Rubber bumper, 1-8
S
Screw pin 3/16 inch hex, 3-11, 3-12
Screw pin 3/8 inch hex, 3-11, 3-12
Side block, 1-24
Slave level cylinder, 1-21, 2-31, 2-32
Slide block, extend cylinder, 1-21
Slide pad, 1-21
Slide pad shim, 1-21
Spacer, air cleaner, 1-24
Spindle nut, 1-7
Spindle nut washer, 1-7
Steering hub, 1-7
Steering yoke, 1-7
Swing drive, 1-8
Switch knob, 3-11, 3-12
Switch seal, 3-11, 3-12
Switch, emergency stop push/pull, 3-12
Switch, keyed start, 3-11
Switch, steer, 3-8
Switch, toggle, 3-11, 3-12
T
Thermal circuit breaker, 15 amp, 3-11
Thermal circuit breaker, 20 amp, 3-11
Tie rod, 1-2
Tilt alarm 5°, 1 second delay, 1-13
Time delay module, 3-8, 3-11
Timing link, 1-18
Tip end bracket, 1-24
Tire, foam filled 9.5 x 16.5 - 8 ply, 1-4
Top arm, 1-18
Top channel, hose guide, 1-18
Top follower bar, 1-18
Traction controller, 3-5, 3-6
Transfer tube, 2-21
U
Upper control box, 3-12
Upper controls switch circuit board, 3-12
W
Warning light, amber lens, 4-9
Warning light, red lens, 4-9
Warranty
See inside back cover
Wire DC/DC transient suppresser, 1-3
Wire harness, auxiliary comps, 3-8
Wire harness, boom, 1-24
Wire harness, BTR transient suppressor, 3-8
Wire harness, chassis - GE drive, 3-8
Wire harness, drive, 3-5, 3-6
Wire harness, electric circuit, 1-24
Wire harness, gauge panel, 3-18
Wire harness, limit switch, 3-16
Wire harness, platform foot switch, 3-17
Wire harness, pump charge up, 3-8
Wire harness, turntable valves, 1-13
index 2 ATB 46e – 01-97 through 01-01
Index