Manual

BDIUSA.COM | 9NEED ASSISTANCE? [e-mail]
ASSEMBLY
STEP 4. INSTALL BACK PANELS
These steps are to be followed after you have unpacked and completed the simple assembly instructions
for your console. Due to jostling in freight or perhaps an uneven floor, the doors on your cabinet may
not appear to be in perfect alignment. Making a few minor adjustments can rectify this situation. The
high-quality European hinge hardware is adjustable. Through a little adjustment, you can modify the
orientation of the cabinet doors to make sure that they are sitting perfectly on your unit.
FINE TUNING
Tightening SCREW 1 on top hinge will open
the seam between Door C & Door D here
Loosening SCREW 1 on this hinge will close
the seam between Door C & Door D here
Door A Door B Door C Door D
Door C
The doors on your cabinet should be evenly
spaced and the doors should open and close
freely without rubbing against the door frame. If
the cabinet’s doors appear out of alignment, this
condition can be corrected with minor adjustment
to the European hinges on each door. Because
these hinges are adjustable, adjusting one hinge element can sometimes cause the need for
adjustments to other elements. But with a few adjustments, you can modify the orientation of the
cabinet doors to make sure that they hang perfectly within your cabinet.
Use a (T1) PHILLIPS SCREWDRIVER to adjust the door hinges:
n By adjusting SCREW 1, the door will move LEFT or RIGHT within the frame. Make minor
adjustments at both top and bottom hinges for best results.
n By adjusting SCREW 2, the door will move UP or DOWN.
n By adjusting SCREW 3 the entire door will move IN or OUT, opening or closing the gap between
the door frame and cabinet. (This screw rarely needs adjustment.)
PART/DESCRIPTION QTY
T1-PHILLIPS
SCREWDRIVER
1
ADJUST DOOR HINGES (IF NEEDED)
1 2 3