Data Sheet

BDE-BLEM301
Bluetooth 5.1 LE Module
Datasheet
[e-mail]
BDE Technology Inc.
23 / 24
minimum of 20cm separation between antenna and body.
The host product manufacturer would provide the above information to end users in their end-product
manuals.
2.7 Antennas
PCB antenna: 2.9dBi, 2.402 GHz~2.480GHz
2.8 Label and compliance information
The end product must carry a physical label or shall use e-labelling followed KDB784748D01 and KDB
784748 stating “Contains Transmitter Module FCC ID: 2ABRU-BLEM301”.
2.9 Information on test modes and additional testing requirements
For more information on testing, please contact the manufacturer.
2.10 Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (FCC Part 15.247) listed on the
grant, and that the host product manufacturer is responsible for compliance to any other FCC rules that
apply to the host not covered by the modular transmitter grant of certification. The final host product
still requires Part 15 Subpart B compliance testing with the modular transmitter installed when contains
digital circuitry.
11.2. FCC Statement
Integrator is reminded to assure that these installation instructions will not be made available to the
end user of the final host device.
The final host device, into which this RF Module is integrated has to be labelled with an auxiliary label
stating the FCC ID of the RF Module, such as "Contains FCC ID: 2ABRU-BLEM301”.
"This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation."
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
(OEM) Integrator has to assure compliance of the entire end-product incl. the integrated RF Module.