Installation Instructions

Wireless Charger- WPC003-1

This wireless charger can charge your Qi-enabled smartphone. Just simply place your smartphone on the

rubber mat above the wireless charger. The wireless charger supports up to 5W power delivery.

NOTE: The wireless charger may not work if your phone case is metal. Take the phone out of the case and

place the phone on the charger.

FCC Certification

FCC ID:2AXPS-WPC003-1

The devices listed above comply with Part 15 of the FCC rules and Industry Canada's license- exempt RSS

Standard(s) and EU Directive 2014/53/EU.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference; and

2. This device must accept any interference received, including interference that may cause

undesired operation.

Note: Radiation Exposure Statement

The product comply with the FCC/IC RF Exposure for Low Power Consumer Wireless Power Transfer. RF

exposure limit set forth for an uncontrolled environment and are safe for intended operation as

described in this manual. The further RF exposure that compliance was demonstrated at 20cm and

greater separation from the user body or set the device to lower output power if such function is

available.

Canada

CAN ICES-3 (B)/NMB-3(B)

Caution: This equipment and its antennas must not be co-located or operated withanother antenna or

transmitter.

Caution: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

PAGE 1
Wireless Charger- WPC003-1 This wireless charger can charge your Qi-enabled smartphone. Just simply place your smartphone on the rubber mat above the wireless charger. The wireless charger supports up to 5W power delivery. NOTE: The wireless charger may not work if your phone case is metal. Take the phone out of the case and place the phone on the charger.
PAGE 2
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.