Data Sheet

Specications Sigma D25 | 1www.bcn3d.com
BCN3D Sigma D25
Specications
3D Printing Technology Fused Filament Fabrication (FFF)
Architecture Independent Dual EXtruder (IDEX)
Printing volume 420mm x 300mm x 200mm
Number of extruders 2
Warranty
2 years for EU countries
1 year for non-EU countries
Extruder system
Extruder Bondtech™ high-tech dual drive gears
Hotends optimized and manufactured by e3D™
Printing modes
Single mode
Duplication mode
Mirror mode
Multimaterial mode
Soluble Supports mode
Electronics
Single Board Computer: Toradex ARM Compute Module
Motion Board: BCN3D Electronics with Independent Stepper Drivers
Firmware
BCN3D Embedded Linux distribution
BCN3D Sigma D25 - Marlin
Heated bed Silicone thermal pad
Printer properties
750 mm
530 mm
690 mm