Operating Instructions

TRKD RPM200 Kit
Manual
TRKD
IN THE BOX
WB200 Health Watch x 1
Health Watch Charger x 1
USB Wall Adapter x 1
Blood Pressure Cuff x 1
MT100 Mini Tablet x 1
Tablet Stand x 1
Customer Service [phone]
HRV Measurement
Bluetooth (BT) No Connection
TRKD Home Care App Manual
Step 1:
Tap touchpad six times to locate the HRV
option on LED display.
Step 2:
Press touchpad for four seconds with index
finger only until the 0% icon shows on LED
Display flashing. While LED display shows
0%, remove finger from health watch, sit
back, peacefully breathing, and remain
motionless in a comfortable position until
100% complete. Takes approximately 2
minutes. Health watch vibrates when
complete and results appear.
BT may lose connection due to interference from
devices around even your Mini tablet. Health watch
and Mini tablet BT range is 15 ~ 20 feet.
In case BT connection does not reconnect
automatically, please close and open the APP to
restore connection.
Restart your mini tablet as needed if relaunching
the APP failed to sync with the health watch.
In LED Display for status, a “check mark”
represents BT is connected and an “X” represents
no connection.
The App receives data from WB200 daily.
Disclaimer
All measurements are estimates and are for reference
ONLY. Please consult a doctor as needed.
The device complies with Part 15 of the FCC Rules.
Dashboard
Today’s
Steps
Heart Rate
HRV
SpO2
Blood oxygen level.
PTT Pulse Transmit Time Index - Systolic & Diastolic
BP Cuff
Blood pressure measured with Blood Pressure
Cuff device.
Heart Rate
Heart rate measured with Blood
Pressure Cuff device.
Notification
FCC Statement (cont..)
Notifications received from TRKD team or
generated by alerts.
Total Active
Minutes
Total active minutes today.
Displays all latest data. Tap each subsection to see
detail of the data received.
This is the steps equivalent or movement you have
during the day. Your latest heart rate received.
Tap further to see heart rate history. Heart rate data
is heart rate average every five minutes.
Heart rate variability, is a measure of the variation in
time between each heartbeat, usually during sleep.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that may cause undesired operation of the
device.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
To display the FCC ID- Long tap on touch button in Vital Summary page to display FCC ID.
You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user’s authority to operate the equipment.
Federal Communications Commission
(FCC) Statement