User`s manual

SQ575
12
Power Management Setup Menu
ROM PCI/ISA BIOS (2A59IB3G)
POWER MANAGEMENT SETUP
AWARD SOFTWARE, INC.
Power Management :
Disable
** Reload Global Timer Events **
PM Control by APM :
Yes
IRQ [3-7,9-15], NMI : Disabled
Video Off Method :
V/H SYNC+Blank
Primary IDE 0 : Disabled
Video off After Suspend : Yes Primary IDE 1 : Disabled
Secondary IDE 0 : Disabled
Doze Mode : Disable Secondary IDE 1 : Disabled
Standby Mode : Disable Floppy Disk : Disabled
Suspend Mode : Disable Serial Port : Disabled
HDD Power Down : Disable Parallel Port : Disabled
VGA Active Monitor : Disabled
PWR-BTTN: : Delay 4 sec.
Resume by Ring : Disabled
Break Event From Suspend
IRQ8 clock event :
Disabled

ESC : Quit
↑↓→←
: Select Item
F1 : Help PU/PD/+/- : Modify
F5 : Old Values (Shift)F2 : Color
F7 : Load Setup Defaults
Figure 5
4.6.1 Power Management
This option allows you to select the type (or degree) of power saving for Doze, Standby, and
Suspend modes. See the section PM Timers for a brief description of each mode. This table
describes each power management mode:
Disable Global Power Management will be disabled
Max Saving
Maximum power savings. Only Available for SL CPUs. Inactivity
period is 1 minute in each mode.
User Define Set each mode individually. Select time-out periods in the PM Timers
section, following.
Min Saving Minimum power savings. Inactivity period is 1 hour in each mode
(except the hard drive).
4.6.2 PM Control by APM
If Advanced Power Management (APM) is installed on your system, selecting Yes gives better
power savings.
4.6.3 Video Off Method
Determines the manner in which the monitor is blanked.
V/H
SYNC+Blank
System turns off vertical and horizontal synchronization ports and
writes blanks to the video buffer.
DPMS Support Select this option if your monitor supports the Display Power
Management Signaling (DPMS) standard of the Video Electronics
Standards Association (VESA). Use the software supplied for your
video subsystem to select video power management values.
Blank Screen System only writes blanks to the video buffer.