User manual

SySTIUM
®
TECHNOLOGIES MotherBoard Ready
SM
System • MODEL 526
Copyright © 2012, Systium® Technologies, LLC
PN: 91171-05 Rev 01
NOTE
Before installing the top side cover please check that all cables are
connected and no tools, screws or accessories are left inside the
chassis.
1. Position the cover down on top of the chassis about 1
inch away to the rear of where the cover’s finally closed
position. Slide the cover forward to engage the cover
locking tabs to the chassis.
2. Attached the cover to the chassis using the three
screws used to initially secure the cover to the chassis.
See Figure 1.
NOTE
The Model 526 utilizes a power supply with an Energy Hazard on the
12V circuit. Compliance with CE requires installation of the cover
lock tab and a lock or the use of the 6-32 TORX screw supplied to
secure the top cover.
Install the Chassis Feet - Desktop
1. Turn the unit upside down. Place the unit on a surface
that will not scratch the top cover. Place the template
supplied in the accessory kit in one of the corners of the
bottom surface of the computer. Refer to Figure 19.
2. Remove the paper backing from the rubber foot and
install the foot sticky side down into the circular opening
in the template. Press on the foot to make sure it
attaches firmly to the bottom of the computer. Refer to
Figure 19.
3. Repeat steps 1 & 2 to install the other three feet. Turn
the computer over and remove the protective cover from
the top cover.
Install the Chassis Feet - Tower
1. Remove the protective cover from the top cover.
2. Turn the computer such that the I/O card end of the
computer is at the top. Place the unit on a surface that
will not scratch the cover. Place the template supplied in
the accessory kit in one of the corners of the bottom
surface of the computer. Refer to Figure 20.
3. Remove the paper backing from the rubber foot and
install the foot sticky side down into the circular opening
in the template. Press on the foot to make sure it
attaches firmly to the bottom of the computer. Refer to
Figure 20.
4. Repeat steps 2 & 3 to install the other three feet.
Power up the System
1. Connect the keyboard, mouse, monitor and any other
required peripheral for the correct operation of the
computer. Refer to the Model Guide for assistance in
connecting the peripherals to the computer.
2. Turn on the computer by pressing the power switch on
the front panel. Refer to the Quick Start Section of this
manual for more information.
3. Verify the operation of the POWER ON indicator on the
front panel. The LED should glow constantly when the
computer is turned on. Verify that the floppy LED turns
on when the system resets the floppy drive during the
POST. Verify the operation of the hard drive LED on the
front panel. The LED should turn on when the POST
resets the hard drive or attempts to boot the computer.
Correct any problems detected during the initial power
up phase.
4. Test the complete operation of the computer using a
known good computer functional test program such as
Intel’s Test view. Install any required operating system
or application software.
NOTE
The computer must have all the required warning and information
lights functioning before shipping to the end user.
5. Disconnect the computer from the peripherals used
during the testing phase. Package the computer using
the original packaging.
NOTE
You must include the End User Quick Start
manual in the shipment to the customer to
maintain Regulatory Compliance.
FIGURE 19
FIGURE 20