User manual

SySTIUM
®
TECHNOLOGIES MotherBoard Ready
SM
System • MODEL 526
Copyright © 2012, Systium® Technologies, LLC
PN: 91171-05 Rev 01
1. Connect the SATA or IDE HD cable to the hard drive.
Route the cable along the bottom of the drive towards
the front of the chassis.
2. Connect the floppy cable to the floppy. The route the
cable over the HD cable and directly to the other board.
Attached the floppy cable to the motherboard.
3. Connect the SATA or IDE HD cable to the motherboard.
Route the cable over top the floppy cable.
4. Connect the IDE cable for the 5.25” peripheral to the
secondary IDE connector on the motherboard. Fold the
cable into a flat bundle to shorten up the cable. Position
the drive end of the cable to the rear of the chassis.
Install the 5.25”Peripheral Carrier
1. Lower the 5.25” carrier into the chassis and insert the
carrier into the 5.25” opening in the front of the chassis.
. The carrier must fit inside the 5.25” chassis opening
flanges. See figure 16.
2. Line up the three mounting holes on the carrier with the
corresponding holes in the chassis. The mounting
flange at the side of the carrier is mounted on top of the
3.5” carrier mounting tab. See Figure 16.
3. Connect the IDE cable to the 5.25 peripheral. See
Figure 16.
Connect the Peripheral Power Cables
1. Connect the peripheral power cables as required. Route
the cables so that there is no cables passing over top
the CPU cooling fan. Use the tie-wraps included in the
integration kit to secure the cables together to ensure
clean routing.
Install Cover Lock Tab
NOTE
The Model 526 utilizes a power supply with an Energy Hazard on the
12V circuit. Compliance with CE requires installation of the cover
lock tab and a lock or the use of the 6-32 TORX screw to secure the
top cover.
1. Locate the locking tab and mounting screw in the
accessory package.
2. Position the locking tab in the notch in the power supply
side of the back of the chassis. Secure the locking tab to
the chassis using the screw supplied. Refer to Figure
17.
Install the Front USB Module (Optional)
NOTE
Perform this assembly step if the system requires the front USB option
installed.
1. Remove the front bezel. Refer to the previous section”
Removing the Front Bezel” for instructions.
2. Locate the front USB access cover. Remove the access
cover by inserting a flat screwdriver into the cover and
flexing it until the cover breaks away from the chassis.
See Figure 18.
3. Remove the front USB module part # 52526-01C from
the box. Using the screws supplied with the USB
module, secure the USB module to the front of the
chassis. See Figure 18.
4. Using the cable supplied with the front USB module
connect the USB module to the motherboard. Refer to
the instructions supplied with the motherboard for the
front panel USB connector.
5. Remove the USB filler panel from the bezel. Refer to
Figure 8. Reinstall the bezel. Line up the bezel mounting
clips and push the bezel towards the chassis to engage
the mounting clips.
Install the Top Cover
FIGURE 16
FIGURE 17
FIGURE 18