User manual

SySTIUM
®
TECHNOLOGIES MotherBoard Ready
SM
System • MODEL 526
Copyright © 2012, Systium® Technologies, LLC
PN: 91171-05 Rev 01
Installing a 5.25” External Peripheral
NOTE
The system must have one 5.25" external peripheral installed or an
EMI shield must be installed. Failure to install a 5.25" external
peripheral or EMI shield can result in EMI leakage that will result in
the computer system not meeting the product's EMC compliance.
1. If the 5.25” carrier is not already removed you must
remove it. To remove the 5.25” carrier following the
instructions in the section “Removing the
5.25”Peripheral Carrier”.
2. Configure any jumpers or switch settings required by the
peripheral. Refer to the peripheral's user manual for
specific instructions.
3. Position the peripheral in the 5.25 carrier as shown in
Figure 11. Line up the peripheral mounting holes with
the carrier mountings holes marked with a “3”. Using the
supplied M3 screws, attach the peripheral to the carrier.
Installing a Second 3.5” Hard Drive Part
Number 52635-00
1. If the 5.25” carrier is not already removed you must
remove it. To remove the 3.5” carrier following the
instructions in the section “Removing the
5.25”Peripheral Carrier”.
2. The second HD carrier must be attached to the 5.25
peripheral carrier before the HD is installed. Refer to
Figure 12.
3. Position the second HD carrier such that the mounting
tabs locking into the mounting locations on the 5.25
peripheral carrier. Secure the second HD carrier to the
5.25 peripheral carrier using the two supplied screws.
Refer to Figure 13.
4. Configure any jumpers or switch settings required by the
peripheral. Refer to the peripheral's user manual for
specific instructions.
5. Insert the 3.5” peripheral (HD Shown) into the carrier.
The power and signal connectors should be oriented
towards the rear of the chassis once the carrier is
installed. Align the 3.5” peripheral mounting screws with
the mounting holes in the carrier marked HD. Secure
the peripheral to the carrier using the shouldered 6-32
mounting screws supplied. Refer to Figure 14.
Install the 3.5”Peripheral Carrier
1. The 3.5” peripheral carrier is mounted in the chassis by
two guide rails and a mounting tab. The carrier must
also fit inside the 3.5” chassis opening flanges. See
figure 15.
2. Lower the carrier into the chassis such that the carrier is
held between the two guides. Slide the carrier forwards
to position the floppy correctly in the 3.5” chassis
opening.
3. Push the carrier forward until the ejector level latches
into place.
Connect Peripheral Cables
FIGURE 11
FIGURE 12
FIGURE 13
FIGURE 14
FIGURE 15