User manual
SySTIUM
®
TECHNOLOGIES MotherBoard Ready
SM
System • MODEL 526
Copyright © 2012, Systium® Technologies, LLC
PN: 91171-05 Rev 01
Removing the Bezel Filler Panels
1. To remove the peripheral filler panels push the
mounting tabs toward each other to release the panel
from the bezel. See Figure 8
Removing the 3.5”EMI Shield
NOTE
Only when a 3.5”external peripheral is being installed should the
3.5”EMI shield be removed. Failure to install a 3.5" external
peripheral can result in EMI leakage that will result in the computer
system not meeting the product's EMC compliance.
1. Remove the two screws holding the 3.5”EMI shield in
place. Remove the 3.5”EMI shield. Refer to Figure 9
Installing a 3.5” External
Peripheral (Floppy)
1. If the 3.5” carrier is not already removed you must
remove it. To remove the 3.5” carrier following the
instructions in the section “Removing the 3.5”Peripheral
Carrier”.
2. Configure any jumpers or switch settings required by the
peripheral. Refer to the peripheral's user manual for
specific instructions.
3. Locate the 3.5” peripheral carrier removed earlier.
4. Position the floppy drive in the 3.5” carrier as shown in
Figure 10. Line up the floppy mounting holes with the
carrier mountings holes marked with a “2”. Using the
supplied M3 screws, attach the floppy to the carrier.
Installing a 3.5” Peripheral (Hard Drive)
1. If the 3.5” carrier is not already removed you must
remove it. To remove the 3.5” carrier following the
instructions in the section “Removing the 3.5”Peripheral
Carrier”.
2. Configure any jumpers or switch settings required by
the peripheral. Refer to the peripheral's user manual for
specific instructions.
3. Insert the 3.5” peripheral (HD Shown) into the carrier.
The power and signal connectors should be oriented
towards the rear of the chassis once the carrier is
installed. Align the 3.5” peripheral mounting screws with
the mounting holes in the carrier marked HD. Secure
the peripheral to the carrier using the shouldered 6-
32 mounting screws supplied. Refer to Figure 10a.
FIGURE 7
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 10a