User manual

SySTIUM
®
TECHNOLOGIES MotherBoard Ready
SM
System • MODEL 526
Copyright © 2012, Systium® Technologies, LLC
PN: 91171-05 Rev 01
Installing the I/O Shield (Intel BOX Motherboard)
1. Locate the motherboard I/O shield supplied with the Intel BOX
motherboard.
2. Place the lower surface of the I/O shield in the I/O opening in
the rear of the chassis. Ensure the I/O shield is fully inserted into
the opening. Refer to Figure 5
3. Carefully press the top surface of the I/O shield into the I/O
opening. Be careful to only place pressure at the outer edges of
the I/O shield when pressing on the I/O shield.
4. Check that the I/O shield is fully inserted into the I/O opening.
NOTE
Failure to properly install the I/O shield can result in EMI leakage
that will result in the computer system not meeting the product's EMC
compliance.
Installing the Motherboard
1. Specific Motherboard may require the installation of a screw-in
standoff(s) in the chassis base to mount the motherboard to. The
standoff(s) are included with the integration kit. Refer to the
assembly instructions for the specific motherboard being installed
into the chassis.
2. Following the instructions supplied with the motherboard,
install the CPU and memory. Ensure that the recommended ESD
protection guidelines are followed.
3. Place the motherboard on the mounting supports. Carefully
slide the motherboard towards the rear of the chassis to engage
the motherboard connectors into the I/O shield openings. Refer
to the assembly instructions for the specific motherboard being
installed for a figure of the correct installation of the motherboard
into the I/O shield.
4. Using the mounting screws supplied, mount the motherboard
to the chassis. Ensure that the motherboard is fully inserted into
the I/O shield while being tightened into place.
5. Connect the front panel connectors to the motherboard. Refer
to the motherboard manual for the correct positions. Refer to
assembly instructions for the specific motherboard being installed
for a figure of the correct installation of the front panel
connectors.
6. Connect the ATX power connector to the motherboard. Refer
to the motherboard specific assembly instructions for any
additional motherboard power connections.
Installing a I/O Adapter (Optional)
NOTE
The Model 526 system supports Motherboard with a variety of I/O bus
slots. The instructions to install the adapters are the same. Care must
be taken to install the adapter in the correct I/O slot.
1. Remove the screw holding the I/O card hold-down
bracket.
1. Rotate the bracket away from the chassis. Refer to
Figure 6
2. To remove the I/O slot cover, slide the cover upwards
and away from the back of the chassis.
3. Refer to the PCI-E video adapter manual for any
installation or configuration steps that need to be
completed before installing the adapter into the chassis.
4. Install the I/O adapter. Refer to the motherboard manual
for any motherboard specific installation instructions.
5. Rotate the I/O hold-down bracket into place to secure
the I/O cards to the chassis. Secure the I/O card hold-
down bracket in place by installing the screw removed in
step 1.
Removing the Front Bezel
The front bezel must be removed to allow removal of the 3.5”EMI
shield (if an external 3.5”device is being installed). The bezel
must also be removed for installation of the front panel USB.
1. Grasp the front bezel at the outer edges. Refer to Figure
7.
2. The bezel is held on by two spring clips. Pull the bezel
away from the front of the system to remove.
FIGURE 5
FIGURE 6