User manual

SySTIUM
®
TECHNOLOGIES MotherBoard Ready
SM
System • MODEL 526
Copyright © 2012, Systium® Technologies, LLC
PN: 91171-05 Rev 01
BULK PACKAGE
Please re-cycle the packaging. None of the bulk pack packaging
is designed for reuse when shipping to the end customer.
CONTENTS
The Model 526 MotherBoard Ready System product contains
the following:
• Model 526 Chassis with Power Supply Installed
• North American Compliant Power Cord
• Integration Kit
• Quickstart Guide. (This manual must be included in
shipment to the End User.)
• Manual
Removing a Side Cover
NOTE:
The system covers are protected with a plastic film. This film must be
removed from the top over before the unit is turned on. It is
recommended that the film be left in place during assembly.
1. Remove the plastic bag protecting the chassis. Save the
bag for shipping the assembled computer.
2. Remove the three screws securing the top cover to the
chassis. Refer to Figure 1
3. Place a hand on each corner of the top cover. While
putting pressure on your fingers use your thumb to push
the chassis forward. This will cause the cover to
separate from the chassis base. Refer to Figure 2
4. Lift the top cover upwards and away from the chassis.
Place the cover to the side where it will not get
scratched or damaged before reassembly.
Removing the 5.25” Peripheral Carrier
NOTE:
The system must have a 5.25" external peripheral installed or an
EMI shield must be installed. Failure to install a 5.25" external
peripheral or EMI shield can result in EMI leakage that will result in
the computer system not meeting the product's EMC compliance.
A 5.25" EMI shield is not supplied with the Model 526 and must be
ordered separately from Systium
The 5.25” peripheral carrier must be removed to install the 5.25
peripheral.
1. Remove the three screws holding the 5.25” carrier to the
chassis. Refer to Figure 3
2. Grasp the 5.25” carrier at the rear and pull the carrier towards
the rear of the chassis. Once the carrier is separated from the
chassis place it aside for installation of the 5.25” peripheral.
Removing the 3.5”Peripheral Carrier
1. The 5.25” peripheral carrier screws must have been removed
by completing the previous section of instructions. See Figure 3
2. Pull back on the 3.5”carrier ejector level and release the carrier
from the chassis. Once the carrier is separated from the front of
the chassis the carrier can be lifted out of the chassis. See Figure
4. Place the carrier a side for installation of the 3.5” peripherals.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4