User manual

I/O Shield

The Itox G7V300 motherboard uses the I/O shield supplied with the

motherboard. Refer to the main assembly guide for instructions on

installing the I/O shield.

Installing the Motherboard

STANDOFF INSTALLATION

1. Install the standoff, included in the chassis integration kit, in

location X as shown in the figure below.

HEATSINK INSTALLATION

1. Install the CPU following the instructions provided with the CPU.

2. Insert the heat sink support bracket into the motherboard from

the underside of the motherboard. The standoffs on the bracket

are inserted into the holes in the motherboard. Refer to Figure 1

NOTE

Make sure the top surface of the heat sink support bracket has the

mylar insulator. Failure to have the insulator in place will result in

the board not working.

FIGURE 1

3. Turn the motherboard over while holding the support bracket in

place. Place the new heat sink on the motherboard with the fan

to the front. Attach the heatsink using the 4 built-in screws. See

Figure 2

FIGURE 2

4. Connect the heatsink fan power cable to the motherboard. Refer

to Figure 2

INSTALLATION OF FRONT PANEL CONNECTORS

Connect Fan and Peripheral Cables

Connect the fan power Y-cable (PN: 10422-00) to the motherboard

fan connector. Connect the fans to the Y-cable. Connect the

peripherals. Refer to the Model 526 Assembly Guide for the

suggested peripheral cable routing.

ITOX

G7V300 ASSEMBLY INSTRUCTIONS

PN: 91186-00

SySTIUM

TECHNOLOGIES MOTHERBOARD READY

SYSTEM • MODEL 526