User`s manual

- 32 -
Installation
4.6 Primary IDE Drives
4.6.1 Primary Master
Select Auto BIOS will detects if a drive is installed and its CHS parameters. If Manual
is select, CHS parameters needs to be insert manually. Select None for no IDE drive
installed.
Drive Type:
None No IDE drive is installed
Manual Enter drive CHS parameters
Auto BIOS detects if a drive is installed and its CHS parameters
Mode:
Auto BIOS check if the drive supports LBA mode, if so LBA mode is
enable and used, otherwise CHS mode is use
CHS Enter drive Cylinder , Head, Sector manually.
UDMA:
Configure PIO or UDMA modes of the IDE device.
4.6.2 Primary Slave
Select Auto BIOS will detects if a drive is installed and its CHS parameters. If Manual
is select, CHS parameters needs to be insert manually. Select None for no IDE drive