User`s manual

- 19 -
Installation
The module mounts in a small opening on the system case that supports this feature.
The efficient distance is 100cm and the transfer rate is 115,200 b its/s.
Reset Switch Connector (Pins 5, and 7)
This connector supports the front panel case-mounted reset button. It is advised
that the reset switch be used for rebooting the system in order to extend the life of
the system’s power supply.
HDD LED Connector (Pins 1, and 3)
The motherboard supports one 2-pin connector for connecting to front Panel Hard
Disk activity LED indicator.
Sleep Switch Connector (Pins 10, and 12)
When the APM (Advanced Power Management) feature is enabled in the system
BIOS and the operating system’s APM driver is loaded, the system can enter the
sleep (standby) mode in one of the following ways:
Ø Optional front panel sleep/resume button
Ø Prolonged system inactivity using the BIOS inactivity timer feature
The 2-pin connector supports a front panel sleep/resume switch, which must be a
momentary SPST type that is normally open
Power Switch Connector (Pins 6, and 8)
This connector supports the ATX case-mounted Power Switch, which in turn
supports System Suspend function. When the BIOS sets the Power Button function
to “Suspend”, the system can be set to the suspended mode once you push the
power switch for no longer than 4 seconds. If the power switch is pushed down for
over 4 seconds, the system will be totally powered off. When this BIOS setting sets
to “Instant-off”, then Power Switch function work as a regular power switch.
Power LED Connector (Pins 2, and 4)
This connector can be connected to a 2-color LED that will light yellow or green
when the computer is in “Suspend” or “Normal” operation.