User`s manual

RX45Q User’s Manual
48
2.2.2.6 Boot Other Device
Use this to boot another device. The options are “Enabled” and “Disabled”.
2.2.2.7 Swap Floppy Drive
A useful feature for those machines that use two floppy drives, when enabled this swaps the A: and B: drives.
This enables you to change the bootable floppy without having to open the case and switch the cable.
2.2.2.8 Boot Up Floppy Seek
Selection of the command “Disabled” will speed the boot up.
Item Description
Enabled Enable Floppy Seek
Disabled Disable Floppy Seek
2.2.2.9 Boot Up NumLock Status
Set the boot up Num Lock status. The options are “On” and “Off”.
Item Description
On Enable NumLock
Off Disable NumLock
2.2.2.10 Gate A20 Option
Item Description
Normal A pin in the keyboard controller controls GateA20
Fast Lets chipset control GateA20 (Default)
2.2.2.11 Typematic Rate Setting
The typematic rate is the rate key strokes repeat as determined by the keyboard controller. The commands
are “Enabled” or “Disabled”. Enabling allows the typematic rate and delay to be selected.
2.2.2.12 Typematic Rate (Chars/Sec)
The BIOS accepts the following input values (characters/second) for typematic rate: 6, 8, 10, 12, 15, 20, 24,
and 30.
2.2.2.13 Typematic Delay (Msec)
Typematic delay is the time interval between the appearances of two consecutive characters, when the key is
continuously depressed. The input values for this category are: 250, 500, 750, and 1000 (ms).
2.2.2.14 Security Option
This category determines whether the password is required when the sys- tem boots up or only when entering
setup. The options are:
Item Description
System
The system will not boot and access to Setup will be denied if the correct password is
not entered at the prompt.
Setup
The system will boot, but access to Setup will be denied if the correct password is not
entered at the prompt.