User`s manual

• SATA1/ 2/ 3/ 4/ 5

Press <Enter> to enter the sub-menu, and the following screen appears:

(SATA1, SATA3, SATA4, SATA5 are controlled through Intel ICH9; SATA2 is controlled through Marvell

88SE6111)

• Device/ Vendor/ Size

It will showing the device information that you connected to the SATA connector.

• LBA/ Large Mode

This allows you to enable or disable the LBA Mode. Setting to Auto enables LBA mode if the device

supports it and the devices is not already formatted with LBA mode disabled.

•DAM Mode

Select DMA Mode.

• Hard Disk S.M.A.R.T.

This allows you to activate the S.M.A.R.T. (Self-Monitoring Analysis & Reporting Technology) Capability for

the hard disks. S.M.A.R.T. is a utility that monitors your disk status to predict hard disk failure. This gives

you an opportunity to move data from a hard disk that is going to fail to a safe place before the hard disk

becomes offine.

SATA1, SATA3, SATA4, and SATA5 are appearing when you connect the HD devices to

the SATA connector on the mainboard. Due to the IDE1 and SATA2 is controlled by

Marvell 88SE6111, the BIS will not detect the IDE & SATA device and will not show the

status.