User manual

MotherBoard Ready
SM
System • MODEL 526EX
Install the Front USB Module (Optional)
NOTE
Perform this assembly step if the system requires the front USB ption
installed.
1. Remove the front bezel. Refer to the previous section”
Removing the Front Bezel” for instructions.
2. Locate the front USB access cover. Remove the access cover
by inserting a flat screwdriver into the cover and flexing it
until the cover breaks away from the chassis. See Figure 18.
3. Remove the front USB module part # 52526-01C from the
box. Using the screws supplied with the USB module, secure
the USB module to the front of the chassis. See Figure 18.
4. Using the cable supplied with the front USB module connect
the USB module to the motherboard. Refer to the
instructions supplied with the motherboard for the front
panel USB connector.
5. Remove the USB filler panel from the bezel. Refer to Figure 8.
Reinstall the bezel. Line up the bezel mounting clips and push
the bezel towards the chassis to engage the mounting clips.
Install the Top Cover
NOTE
Before installing the top side cover please check that all cables are
connected and no tools, screws or accessories are left inside the
chassis.
1. Position the cover down on top of the chassis about 1 inch
away to the rear of where the cover’s finally closed position.
Slide the cover forward to engage the cover locking tabs to
the chassis.
2. Attached the cover to the chassis using the three screws
used to initially secure the cover to the chassis. See Figure 1.
NOTE
The Model 526EX utilizes a power supply with an Energy Hazard on
the 12V circuit. Compliance with CE requires installation of the cover
lock tab and a lock or the use of the 6-32 TORX screw supplied to
secure the top cover.
Install the Chassis Feet - Desktop
1. Turn the unit upside down. Place the unit on a surface that
will not scratch the top cover. Place the template supplied in
the accessory kit in one of the corners of the bottom surface
of the computer. Refer to Figure 19.
2. Remove the paper backing from the rubber foot and install
the foot sticky side down into the circular opening in the
template. Press on the foot to make sure it attaches firmly to
the bottom of the computer. Refer to Figure 19.
3. Repeat steps 1 & 2 to install the other three feet. Turn the
computer over and remove the protective cover from the top
cover.
Install the Chassis Feet - Tower
1. Remove the protective cover from the top cover.
2. Turn the computer such that the I/O card end of the
computer is at the top. Place the unit on a surface that will
not scratch the cover. Place the template supplied in the
accessory kit in one of the corners of the bottom surface of
the computer. Refer to Figure 19.
3. Remove the paper backing from the rubber foot and install
the foot sticky side down into the circular opening in the
template. Press on the foot to make sure it attaches firmly to
the bottom of the computer. Refer to Figure
4. Repeat steps 2 & 3 to install the other three feet.
FIGURE 17
FIGURE 18
FIGURE 19
Copyright © 2013, Systium® Technologies, LLC
PN: 91173-00 Rev 00