User manual

ManualsBrandsBCM ManualsComputer equipmentRX35Q

MotherBoard Ready

System • MODEL 526EX

3. Position the second HD carrier such that the mounting tabs

locking into the mounting locations on the 5.25 peripheral

carrier. Secure the second HD carrier to the 5.25 peripheral

carrier using the two supplied screws. Refer to Figure 13.

4. Configure any jumpers or switch settings required by the

peripheral. Refer to the peripheral's user manual for specific

instructions.

5. Insert the 3.5” peripheral (HD Shown) into the carrier. The

power and signal connectors should be oriented towards the

rear of the chassis once the carrier is installed. Align the 3.5”

peripheral mounting screws with the mounting holes in the

carrier marked HD. Secure the peripheral to the carrier using

the shouldered 6-32 mounting screws supplied. Refer to

Figure 14.

Install the 3.5”Peripheral Carrier

1. The 3.5” peripheral carrier is mounted in the chassis by two

guide rails and a mounting tab. The carrier must also fit

inside the 3.5” chassis opening flanges. See figure 15.

2. Lower the carrier into the chassis such that the carrier is held

between the two guides. Slide the carrier forwards to

position the floppy correctly in the 3.5” chassis opening.

3. Push the carrier forward until the ejector level latches into

place.

Connect Peripheral Cables

1. Connect the SATA or IDE HD cable to the hard drive. Route

the cable along the bottom of the drive towards the front of

the chassis.

2. Connect the floppy cable to the floppy. The route the cable

over the HD cable and directly to the other board. Attached

the floppy cable to the motherboard.

3. Connect the SATA or IDE HD cable to the motherboard.

Route the cable over top the floppy cable.

4. Connect the IDE cable for the 5.25” peripheral to the

secondary IDE connector on the motherboard. Fold the cable

into a flat bundle to shorten up the cable. Position the drive

end of the cable to the rear of the chassis.

Install the 5.25”Peripheral Carrier

1. Lower the 5.25” carrier into the chassis and insert the carrier

into the 5.25” opening in the front of the chassis. . The

carrier must fit inside the 5.25” chassis opening flanges. See

figure 16.

2. Line up the three mounting holes on the carrier with the

corresponding holes in the chassis. The mounting flange at

the side of the carrier is mounted on top of the 3.5” carrier

mounting tab. See Figure 16.

3. Connect the IDE cable to the 5.25 peripheral. See Figure 16.

Connect the Peripheral Power Cables

Connect the peripheral power cables as required. Route the cables so

that there is no cables passing over top the CPU cooling fan. Use the

tie-wraps included in the integration kit to secure the cables together

to ensure clean routing.

Install Cover Lock Tab

NOTE

The Model 526EX utilizes a power supply with an Energy Hazard on

the 12V circuit. Compliance with CE requires installation of the cover

lock tab and a lock or the use of the 6-32 TORX screw to secure the

top cover.

1. Locate the locking tab and mounting screw in the accessory

package.

2. Position the locking tab in the notch in the power supply side

of the back of the chassis. Secure the locking tab to the

chassis using the screw supplied. Refer to Figure 17.

FIGURE 13

FIGURE 14

FIGURE 15

FIGURE 16

PN: 91173-00 Rev 00