User manual

MotherBoard Ready
SM
System • MODEL 526EX
Removing the Bezel Filler Panels
To remove the peripheral filler panels push the mounting tabs toward
each other to release the panel from the bezel. See Figure 8.
Removing the 3.5”EMI Shield
NOTE
Only when a 3.5”external peripheral is being installed should the
3.5”EMI shield be removed. Failure to install a 3.5" external
peripheral can result in EMI leakage that will result in the computer
system not meeting the product's EMC compliance.
Remove the two screws holding the 3.5”EMI shield in place.
Remove the 3.5”EMI shield. Refer to Figure 9.
Installing a 3.5” Peripheral (Hard Drive)
1. If the 3.5” carrier is not already removed you must remove it.
To remove the 3.5” carrier following the instructions in the
section “Removing the 3.5”Peripheral Carrier”.
2. Configure any jumpers or switch settings required by the
peripheral. Refer to the peripheral's user manual for specific
instructions.
3. Insert the 3.5” peripheral (HD Shown) into the carrier. The
power and signal connectors should be oriented towards the
rear of the chassis once the carrier is installed. Align the 3.5”
peripheral mounting screws with the mounting holes in the
carrier marked HD. Secure the peripheral to the carrier using
the shouldered 6-32 mounting screws supplied. Refer to
Figure 10.
Installing a 5.25” External Peripheral
NOTE
The system must have one 5.25" external peripheral installed or an
EMI shield must be installed. Failure to install a 5.25" external
peripheral or EMI shield can result in EMI leakage that will result in
the computer system not meeting the product's EMC compliance.
1. If the 5.25” carrier is not already removed you must remove
it. To remove the 5.25” carrier following the instructions in
the section “Removing the 5.25”Peripheral Carrier”.
2. Configure any jumpers or switch settings required by the
peripheral. Refer to the peripheral's user manual for specific
instructions.
3. Position the peripheral in the 5.25 carrier as shown in Figure
11. Line up the peripheral mounting holes with the carrier
mountings holes marked with a “3”. Using the supplied M3
screws, attach the peripheral to the carrier.
Installing a Second 3.5” Hard Drive Part Number
52635-00
1. If the 5.25” carrier is not already removed you must remove
it. To remove the 3.5” carrier following the instructions in the
section “Removing the 5.25”Peripheral Carrier”.
2. The second HD carrier must be attached to the 5.25
peripheral carrier before the HD is installed. Refer to Figure
12.
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
FIGURE 12
Copyright © 2013, Systium® Technologies, LLC
PN: 91173-00 Rev 00