User manual

ManualsBrandsBCM ManualsComputer equipmentRX35Q

MotherBoard Ready

System • MODEL 526EX

BULK PACKAGE

Please re-cycle the packaging. None of the bulk pack packaging is

designed for reuse when shipping to the end customer.

CONTENTS

The Model 526EX MotherBoard Ready System product contains the

following:

• Model 526EX Chassis with Power Supply Installed

• North American Compliant Power Cord

• Integration Kit

• Quickstart Guide. (This manual must be included in

shipment to the End User.)

• Manual

Removing a Side Cover

NOTE:

The system covers are protected with a plastic film. This film must be

removed from the top over before the unit is turned on. It is

recommended that the film be left in place during assembly.

1. Remove the plastic bag protecting the chassis. Save the bag

for shipping the assembled computer.

2. Remove the three screws securing the top cover to the

chassis. Refer to Figure 1

3. Place a hand on each corner of the top cover. While putting

pressure on your fingers use your thumb to push the chassis

forward. This will cause the cover to separate from the

chassis base.

4. Lift the top cover upwards and away from the chassis. Place

the cover to the side where it will not get scratched or

damaged before reassembly.

Removing the 5.25” Peripheral Carrier

NOTE:

The system must have a 5.25" external peripheral installed or an

EMI shield must be installed. Failure to install a 5.25" external

peripheral or EMI shield can result in EMI leakage that will result in

the computer system not meeting the product's EMC compliance.

A 5.25" EMI shield is not supplied with the Model 526EX and must be

ordered separately from Systium.

1. The 5.25” peripheral carrier must be removed to install the

5.25 peripheral.

2. Remove the three screws holding the 5.25” carrier to the

chassis. Refer to Figure 3

3. Grasp the 5.25” carrier at the rear and pull the carrier

towards the rear of the chassis. Once the carrier is separated

from the chassis place it aside for installation of the 5.25”

peripheral.

Removing the 3.5”Peripheral Carrier

1. The 5.25” peripheral carrier screws must have been removed

by completing the previous section of instructions. See Figure

2. Pull back on the 3.5”carrier ejector level and release the

carrier from the chassis. Once the carrier is separated from

the front of the chassis the carrier can be lifted out of the

chassis. See Figure 4. Place the carrier a side for installation

of the 3.5” peripherals.

Installing the I/O Shield (Intel BOX Motherboard)

1. Locate the motherboard I/O shield supplied with the Intel

BOX motherboard.

2. Place the lower surface of the I/O shield in the I/O opening in

the rear of the chassis. Ensure the I/O shield is fully inserted

into the opening. Refer to Figure 5.

PN: 91173-00 Rev 00