User manual

SySTIUM

TECHNOLOGIES MOTHERBOARD READY

SYSTEM • MODEL 526EX

I/O Shield

The ITOX BL330-BR motherboard uses the I/O shield

supplied with the motherboard. Refer to the main

assembly guide for instructions on installing the I/O shield.

Installing the Motherboard

STANDOFF INSTALLATION

1. Install the standoff, included in the chassis

integration kit, in location 0 as shown in the figure

below.

HEATSINK INSTALLATION

1. Install the CPU following the instructions provided

with the CPU.

2. Insert the heat sink support bracket into the

motherboard from the underside of the

motherboard. The standoffs on the bracket are

inserted into the holes in the motherboard. Refer

to Figure 1.

NOTE

Make sure the top surface of the heat sink support bracket has

the mylar insulator. Failure to have the insulator in place will

result in the board not working.

3. Turn the motherboard over while holding the

support bracket in place. Place the new heat sink

mount on the motherboard. Attach the heatsink

using the 4 built-in screws. See Figure 2.

Connect the heatsink fan power cable to the

motherboard. Refer to Figure 2.

INSTALLATION OF FRONT PANEL CONNECTORS

Connect Peripheral Cables

Refer to the Model 526 Assembly Guide for the suggested

peripheral cable routing.

ITOX BL330-BR ASSEMBLY INSTRUCTIONS

FIGURE 1

FIGURE 2

526EX BL330-BR AI Rev 1.0