User`s manual

Serial ATA Connector: SATA1, SATA2
This connector is a high-speed Serial ATA interface port. Each connector can
connect to one Serial ATA device.
Please do not fold the Serial ATA cable into 90-degree angle. Otherwise, data
loss may occur during transmission.
SPI Flash ROM Header: JSPI1
This header is used to flash SPI flash ROM.
Fan Power Connector: CPUFAN1
The fan power connector supports system cooling fan with +12V. When connecting
the wire to the connectors, always note that the red wire is the positive and should
be connected to the +12V; the black wire is Ground and should be connected to
GND. If the mainboard has a System Hardware Monitor chipset onboard, you must
use a specially designed fan with speed sensor to take advantage of the CPU fan
control.
Pin Descri
p
tion Pin Descri
p
tion
1 VCC3 SB 2 VCC3 SB
3 SPI MISO F 4 SPI MOSI F
5 SPI CS0 F# 6 SPI CLK F
7 GND 8 GND
9 SPI HOLD# 10 NC
2
-
7