User`s manual

38
Onboard FDC Controller
This item allows you to enable/ disable onboard floppy disk controller function.
Available option are Enabled and Disabled
Onboard Serial Port 1
This item allows you to select the serial port 1 I/O/ IRQ to be used.
Onboard Serial Port 2
This item allows you to select the serial port 2 I/O/ IRQ to be used.
Onboard Parallel Port
There is a built-in parallel port on the on-board Super I/O chipset that Provides Standard, ECP,
and EPP features. It has the following option:
Disabled
(3BCH/IRQ7)/ Line Printer port 0
(278H/IRQ5)/ Line Printer port 2
(378H/IRQ7) Line Printer port 1
Parallel Port Mode
SPP : Standard Parallel Port
EPP : Enhanced Parallel Port
ECP : Extended Capability Port
SPP/EPP/ECP/ECP+EPP
To operate the onboard parallel port as Standard Parallel Port only, choose “SPP.” To
operate the onboard parallel port in the EPP modes simultaneously, choose “EPP.” By
choosing “ECP”, the onboard parallel port will operate in ECP mode only. Choosing
“ECP+EPP” will allow the onboard parallel port to support both the ECP and EPP modes
simultaneously. The ECP mode has to use the DMA channel, so choose the onboard parallel
port with the ECP feature. After selecting it, the following message will appear: “ECP Mode
Use DMA” at this time, the user can choose between DMA channels 3 to 1. The onboard
parallel port is EPP Spec. compliant, so after the user chooses the onboard parallel port with
the EPP function, the following message will be displayed on the screen: “EPP Mode Select.”
At this time either EPP 1.7 spec. or EPP 1.9 spec. can be chosen.
Parallel Port Mode
This item allows you to select the parallel port mode to be used.
Available select are SPP, EPP and ECP.
PWRON After PWR-Fail
This item allows you to select the power stage when the main power supply were
interrupted.
Available option: Former-states, On or Off.