User`s manual

37
This item allow you to enable/ disable the Onboard LAN2 Controller . Available option
are Enabled and Disabled.
Init Display First
This item allows you to select first display initialization at system boot up. Available
option are onboard/AGP or PCI.
3-7-3 Super IO Device
Phoenix – AwardBIOS CMOS Setup Utility
Super IO Device
Item Help
Power ON Function [BUTTON ONLY]
KB Power ON Password [Enter]
Hot Key Power ON [Ctrl-F1]
Onboard FDC Controller [Disabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Serial Port 2 [2F8/IRQ3]
UART Mode Select [Normal]
RxD , TxD Active [Hi, Lo]
IR Transimssion Delay [Enabled]
UR2 Duplex Mode [Half]
Use IR Pin [IR-Rx2Tx2]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [SPP]
EPP Mode Select [EPP1,7]
ECP Mode Use DMA [3]
PWRON After PWR-Fail [Off]
Menu Level >>
↑↓→←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
Power ON Function
This item allow you to select system power on method, option are Hot key, Mouse,
Button Only, Password or Any Key.
KB Power On Password
This item allow you to enter your keyboard power on password.
Hot Key Power On
This item allow you to select the Hot Key to power on the system