User`s manual

11
2-4 Install Memory
This motherboard provides one 184-pin DIMM (
D
UAL
I
NLINE
M
EMORY
M
ODULES)
sites for memory expansion available to maximum memory size of 1.0GB DDR SDRAM.
• Support 128Mb, 256Mb, 512Mb technologies implemented as x8, x16 devices.
• ECC, Non-ECC DIMMS.
Valid Memory Configurations
Bank 184-Pin DIMM Total Memory
Bank 0, 1 (DDR0) 200 /266/333 DDR SDRAM Module X1
64MB∼1.0GB
Total System Memory (Max. 1.0GB) 1
64MB∼1.0GB
NOTE!
Make sure the installed memory are DDR266 SDRAM support 133MHz
memory clock, otherwise the system may hang during startup. PC2100/
PC2700 DDR are recommended.
Generally, installing DDR SDRAM modules to your motherboard is very easy, refer to
figure 2-4 to see what a 184-Pin DDR200/DDR266 SDRAM module looks like.
DDR1 (BANK0+BANK1)
NOTE! When you install DIMM module fully into the DIMM socket the eject tab
should be locked into the DIMM module very firmly and fit into its indention
on both sides.
WARNING! For the DDR SDRAM CLOCK is set at 133MHz, use only DDR266-compliant
DDR Modules. When this motherboard operate at 133Mhz, most system will
not even boot if non-compliant modules are used because of the strict timing
issues, if your SDR Modules are not DDR266-compliant, set the DDR
SDRAM clock to 100MHz to ensure system stability.