User`s manual

ManualsBrandsBCM ManualsComputer equipmentMX266

(10) Primary IDE Connector (40-pin block): IDE1 (CN10)

This connector supports the provided IDE hard disk ribbon cable. After connecting the

single plug end to motherboard, connect the two plugs at other end to your hard disk(s). If

you install two hard disks, you must configure the second drive to Slave mode by setting its

jumpers accordingly. Please refer to the documentation of your hard disk for the jumper

settings.

(11) Secondary IDE Connector (44-pin block): IDE2 (CN3)

This connector connects to the next set of Master and Slave hard disks. Follow the same

procedure described for the primary IDE connector. You may also configure two hard disks

to be both Masters using one ribbon cable on the primary IDE connector and another ribbon

cable on the secondary IDE connector.

Secondary IDE Connector

IDE2

Pin 1

•

Two hard disks can be connected to each connector.

The first HDD is referred to as the “Master” and the

second HDD is referred to as the “Slave”.

Signal PIN Signal

GND 1 2 DACT#

DCS3# 3 4 DCS1#

DA2 5 6 DA0

NC 7 8 DA1

NC 9 10 IRQ14

GND 11 12 DACK#

GND 13 14 IORDY

GND 15 16 IOR#

GND 17 18 IOW#

GND 19 20 DREQ

NC 21 22 GND

D15 13 24 D0

D14 15 26 D1

D13 17 28 D2

D12 19 30 D3

D11 31 32 D4

D10 33 34 D5

D9 35 36 D6

D8 37 38 D7

GND 39 40 RESET#